- ページ 3

グリル Dickinson SEA-B-QUE SMALLのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dickinson SEA-B-QUE SMALL 9 ページ。 Propane barbecue
Dickinson SEA-B-QUE SMALL にも: 取扱説明書 (10 ページ), 取扱説明書 (16 ページ)

Close the sea-b-que regulator valve before opening the lpg cylinder valve
Save this manual for future reference.
Sea-B-Que Feet Assembly Instructions
Most of the assembly for your new BBQ has been done for you. You will need to attach
the feet of the BBQ to the rest of the unit. The two feet of the Sea-B-Que slide on to the
inserted studs on the base. The flanges are to point outwards. Use the four 10 x 32 nuts
and #10 lock-washers to secure the legs to the base.
Regulator Control & Propane Fuel Supply
Propane must be supplied from a standard or disposable propane bottle. High pressure
propane is required. The sea-b-que gas control is also the pressure regulator.
boat has a regulated propane source the fuel line to the Sea-b-que must be T'd off before
any regulators on the main fuel supply. The
Dickinson for this purpose (# 15-178). If replacing the regulator control or the Sea-b-
Que is not getting hot enough even after the venturi has been adjusted, the regulator may
need to be adjusted. If so use a bottle that is more than ½ full and light the burner and
turn the control on high, peel the shiny sticker off the front of the control knob. There
will be a Phillips screw or a 5/64 Allen screw. Turn clockwise to increase the flame, at
about ½ turn at a time (no more than 2 full turns).
NOTE- this will affect the low setting as well. If decreasing the flames, turn the screw
counterclockwise in small increments to make sure the flames do not go out on the low
setting on a windy day. Contact Dickinson Marine to receive the new sticker.
www.infodickinsonmarine.com
Use the new sticker to cover the adjusting screw after you are sure it is adjusted to your
liking.
Thermometer
Both the Large and Small Sea-B-Que are fitted with a thermometer. If you remove the
thermometer for cleaning or replacement, refer to Diagram E for re-assembly.
Inspect the thermometer to ensure no small white bits of plastic are around the edge, left
over from the protective plastic used in the manufacturing process.
Be aware that bending or damaging the thermometer probe or dropping the Sea-B-Que,
may cause the thermometer to stop working.
PDF Created with deskPDF PDF Writer - Trial :: http://www.docudesk.com
T type connector is available from
Tel 800 659 9768
If your