- ページ 5

室内暖炉 Dickinson Newport - P9000のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Dickinson Newport - P9000 12 ページ。 Propane fireplace/heater

LOCATION

LOCATE the heater where it will maximize the radiant heating capability. The NEWPORT

PROPANE HEATER is equipped with a manually operated blower fan that will blow hot air

from the top of the heater down onto the floor. This increases heating efficiency and provides

good circulation of hot air.

LOCATE so that the front and sides of the heater are at least 3 ins (75 mm) from combustible

surfaces.

LOCATE to provide easy installation of the flue and external flue cap. The mounting flange of

the thru fitting and cap requires an area of at least 6" (15cm).

LOCATE keeping in mind that the top cap gets hot and that the hot products of combustion are

being emitted when the heater is operating.

NOTE : The direct vent chimney is flexible and can be bent to provide any angle

of offset. The minimum length recommended is 2 ft (60 cm) and the maximum

length 5 ft (1.5m).

Installing the thru-fitting and flue cap at an angle of no more than 45 degree is

not a problem.

We do not recommend installing the thru-fitting and flue cap with a horizontal

exit. If there is no other option the heater will work satisfactorily when the full

length of the exhaust pipe supplied 30 ins (75 cm) is used to achieve the 90

degree angle.

products of combustion are being emitted when the heater is operating.

LOCATE for easy, safe access to the source of propane gas.

MOUNTING

Secure the heater mounting plate directly onto the mounting surface. No additional insulation is

required.

No screws or bolts are provided, as each installation will have different securing

requirements.

www.ahoycaptain.com

INSTALLATION

Again keep in mind that the top cap gets hot and that the hot