- ページ 6

ガスヒーター Dickinson 1000のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Dickinson 1000 15 ページ。 Propane cozy cabin heater

Locate the cylinder and regulator in a locker vented to the open air (preferably on

the deck or cabin top) isolated from the hull interior by a vapor tight enclosure.

Refer to local codes or Coast Guard requirements for details.

Propane is heavier than air.

installed must be vented at the bottom. Position the vent above the water line, and

at least two feet from any hull opening to the boat interior or engine exhaust.

We recommend the installation of a vapor monitor on your boat with all propane fueled

devices.

Propane is a two-phase (liquid/vapor) fuel, and only vapor withdrawal from the

tank is safe. Firmly mount the cylinder, right side up, to ensure that liquid

withdrawal does not occur.

We recommend that a solenoid valve, which can be controlled by a switch located in your

cabin, be installed next to the manual cylinder valve. The cylinder valve outlet and the 12

VDC solenoid valve should be clean and dry when they are connected to each other.

Use Teflon tape or Loctite to seal these connections being very careful to not

introduce any foreign materials into the system that can plug the tiny appliance

orifices.

A 0-300 psi (0-20 bar) pressure gauge may be installed between the bottle and the

regulator to give bottle pressure.

Install the regulator downstream from the pressure gauge with its vent port

pointing downward, which prevents the pressure vent from getting plugged.

** In some cases the solenoid valve is installed on the low pressure side of the

system (i.e. after the LPG regulator). See solenoid manufacturers' instructions

for proper installation.

Therefore, the locker in which the cylinder is

www.dickinsonmarine.com

Form#7.2-70 Issue#2