- ページ 9
インバーター Alpha ESS M4856-SのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Alpha ESS M4856-S 10 ページ。
ページを印刷するConnect Power Line
Step12
Battery communication cable connection sequence:
the RJ45 connector of the communication cables should go through
the waterproof cap → through the seal ring→through the joint and
then plug into the COM port inside of the battery.
HV50056 & Battery communication cable connection sequence:
RJ45 connector on one side should go through the waterproof
connector then be plugged into the COM port inside the battery
which is closest to HV900112. The RJ45 connector on the other side
should go through the waterproof cover inserted into the LMU port
inside the HV50056.
Terminal Resistance:
Plug the terminal resistance into the last COM port of the last battery.
DIP Switch
Step13
DIP switch:
DIP switch defines the ID address of
each battery in one cluster. Set the
DIP switch of the battery that is closest
to the HV50056 as 1 and the farthest
as N. N is the total number of the
batteries, which is min. 4 and max. 8.
Note: There should be no same ID number in
one cluster.
Mounting Appearance Parts
Step14
Reverse step3.
Push the top two guide
A
rods into the housing.
B
Press the buckle from the
bottom in the middle.
1
8
2
7
3
6
4
5
Reverse the disassemble of
HV50056 as explained before
Push the top two guide
A
rods into the housing.
B
Press the buckle from the
bottom in the middle.