計測機器 Dickson ET8のPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Dickson ET8 6 ページ。 Universal input chart recorder

ページを印刷する

Default Logger Settings

Recording Time: 7 day

Range: 0 to 100

Input Range Channel 1 (Red pen)

Input Range Channel 2 (Blue pen)

Quick Start

To change the range and recording time, please reference

Dip Switch Setup in this manual.

1. Insert a 9V battery and plug in AC adapter. The unit will

power on. (see Figure 3)

2. Plug in transducers using uncompensated jacks.

(See figure 3)

Note Be sure to observe proper polarity when

connecting wires from transmitter. (See figure 3)

3. Remove the protective pen caps.

4. Press the ON/OFF key (See figure 2) to turn the

instrument on.

5. The instrument will move pens to the appropriate

readings.

6. Install the chart that matches the "Dip Switch settings"

you have selected.

7. Press the Pen Home key to move the pens to the

outside of the chart. The pens are automatically raised

off the chart.

8. Remove the old chart. Place the new chart on the

"Chart Hub" making certain that the edge of the chart

slides under the "chart guide clips" located at the

outside of the chart.

Display Symbols (Optional)

Low battery

indicator

Alarm

enabled

For setting

Alarms only

www.DicksonData.com • 1-800-323-2448 • Fax 1-800-676-0498

Getting Started

9. Set the appropriate time. There are two ways to

adjust the chart and set the appropriate time:

a. Set the chart time manually by inserting a coin into

the groove in the chart hub and turning clockwise

until the correct hour (and day if applicable) on the

chart is referenced to the timing arrow (just to the

right of the pen tip on the dial).

This feature should be used for fine adjustments only

b. To adjust the chart time, press and hold Adjust-Up

and Adjust-Down buttons located on the back of

the unit next to the dip switch (see Figure 3).

The green LED will blink rapidly for about five

seconds, then the LED will remain solid green.

While in this state the Adjust-Up button will move

the chart backward (counter clockwise) and the

Adjust-Down button will move the chart forward

(clockwise).

Rotate the chart until the correct hour (and day if

applicable) on the chart is referenced to the timing

arrow. Once you have set your chart, press the Pen

Home button to exit "Chart Adjust Mode". The unit

will take one minute to exit the "Chart Adjust Mode"

once Pen Home is pressed.

Press Pen Home to move the pens back onto

the chart.

10. Place the ET8 recorder on a flat vibration-free surface.

Be sure it is in a vertical position and level. For best

performance and longevity, the location should be

a clean environment, free from dust and corrosive

fumes. Do not exceed temperature specifications.

Wall Mount Keyhole slots are provided on the ET8

recorder for wall mounting.

MAX

MIN

ET8

Universal Input

Chart Recorder

Figure 1

Current Reading

Flashing "ALRN" when

in alarm condition

Reading of channel

displayed 1 or 2