- ページ 14

電子タバコ dicodes Dani Box MicroのPDF マニュアルをオンラインで閲覧またはダウンロードできます。dicodes Dani Box Micro 18 ページ。

06 Extended Functions Menu

Additional Explanation to several menu items, page 2

The values shown depend on the operation mode: In temperature controlled mode, the parameters are

the temperature, coil resistance, temperature regulating power and a battery symbol.

For the modes power, boost and heater protection, the selected power (or limited power in case), the coil

resistance and the battery voltage are displayed. When Bypass mode is selected, the coil resistance and

the battery voltage dependent, measured power is displayed, as there is no fixed power setting in

Bypass mode.

The additional modes available with Expert Mode set to 1 are "Power Boost", "Heater Protection" and

"Bypass".

Here again the modes in an overview:

Vaping with a constant power setting. The selected power is applied to the coil, unless

Mode0

the coil's resistance affords a different power setting or power is limited due to other

Power

reasons.

The power applied to the coil is calculated by a temperature controller which keeps the

Mode1

coil's temperature constant. Important to note: Set the correct temperature coefficient

Temp-Cont.

and perform a calibration at room temp.

Mode2

The power applied to the coil is repeatedly interrupted to enable a liquid flow und thus to

Heater-Prot.

limit the temperature.

The coil is quickly heated up initially. Moreover an repetitive boost can be selected.

Mode3

We recommend not to set the boost-power value too low but adjust a lower normal

Power-Boost

power setting to limit the coils temperature rise.

Mode4

The mod behaves like a mechanical mod, i.e. the battery voltage is directly applied to the coil.

Bypass

This, with the restriction, that the maximum current is 22A. Note that the vape now depends

on the charging level of the battery, and the coil should not be too low in resistance as then

22A is the limiting factor. If the resistance is too low in Bypass-mode, Err8 LowR is displayed

and vaping is not possible.

The display mode switches on and off the dynamic display of several parameters

during and after the puff. The setting "cont" (continious) will display values during

and 4 seconds after the vape. With "post" the values are displayed only after the

puff and off disables the display.

The Dani Box Micro can be used in 5 different modes. But in order to keep

the menu as short and simple as possible, 3 of the 5 modes are only available,

if the Expert-Mode is set to 1. The name is Expert-Mode, because the use of

the additional operation modes requires additional knowledge about their

functionality.