- ページ 3

防犯カメラ Axis Videolarm 25734のPDF 製品取扱説明書をオンラインで閲覧またはダウンロードできます。Axis Videolarm 25734 14 ページ。 Videoalarm 25734
Axis Videolarm 25734 にも：製品取扱説明書 (12 ページ)

ELECTRICAL SPECIFICATIONS (OUTDOOR ONLY):

Power 24VAC, Class 2 Only

52 watts at 24 VAC (accessories)

Heater: 50 watts

Blower: 2 watts

NOTE: This unit is designed for operation in an

upright position. Installing the unit upside

down may cause damage to the internal

equipment, and will void the warranty.

GENERAL INSTRUCTIONS:

Tools Required: .100" Flat Head Screwdriver

Phillips Head Screwdriver

Be sure the bracket is properly and securely

mounted to a supporting structure capable of

rigidly holding the weight of the entire unit.

1. Remove the contents of the box onto a table. The larger

subassembly box is the housing assembly. The smaller

subassembly box is the dome assembly. (Picture 1)

Picture 1

2. Open the housing assembly box. Note there is a small roll

of Teflon Tape that will be needed during installation, put it

aside. (Picture 2)

Picture 2

3, Open the dome assembly box. Note there is a protection

film on the dome. DO NOT REMOVE the film until the

product is fully assembled and installed. This film protects

the dome from scratches during installation. (Picture 3)

Picture 3

4. There is a safety lanyard that is attached to the inside of the

housing assembly. Remove the phillips head screw on the

trim ring assembly and then attach the lanyard to the trim

ring with the phillips head screw.

5. The safety lanyard is now attached to the housing

(Picture 5).

Listed on the following pages are the specific instructions

for each of the individual network cameras. See specific

instruction for the model that matches the unit you have.

- -

Teflon Tape

Attach Lanyard

to Trim Ring

Picture 5