セキュリティセンサー Alpha Motors RS005のPDF 使用方法をオンラインで閲覧またはダウンロードできます。Alpha Motors RS005 3 ページ。 Motion sensor

ページを印刷する

ALPHA RS005 Motion Sensor Instructions

Note: cannot be used in conjunction with a sun/wind sensor

Techanical data:

Battery: 2 x AAA

Protection Index: IP44

Frequency: 433.92MHz

The Parts:

Learning button

Indicator light

Orientation switch for front/back or

Sensitivity switch

underside installation

(Shown in front/back position)

Mounting Base

Channel fixings

Opening the unit.

Installation:

Firstly, find a suitable position on the front bar of the folding arm awning to house the motion sensor. This

position should not obstruct the operation of the awning and should ideally allow the motion sensor to be

secured to the hollow channel and be close to either end. Mounting near the centre will affect the quality of

operation. The device can be mounted on either the front, back or underside of the bar as circumstances

allow.

Working current: 8mA

Temperature: -20℃ to +60℃

AAA battery x 2

Inner Casing

Outer Cover

(Contains the circuit board)

(Contains the inner casing and

clips onto the mounting base)

Underside Mount

NOTE: Make sure to select the correct switch position on the circuit board for the mounting position used.

This is a crucial step , as incorrect switch position will render the unit unreliable or inoperable.

Setup

Select the correct position on the orientation switch (see image below)

NOTE: If mounted to the front or back of the leading bar then put switch into position 1.

If installed on the underside of the leading bar, then put switch into position 2.

Position 2

underside

Position 1

front/back

Install Batteries

Install 2 x AAA Alkaline batteries in the battery holders . The LED will flash to confirm the batteries are

correctly installed. If not, check if the batteries' + and – are correct.

Learning button

1. Assigning the Motion Sensor to the motor

Pick up the awnings remote and make sure it is on the correct channel for the awning if it's a multi-

channel remote.

Press remote's up and down simultaniously then release, then press stop 8 times, the motor will jiggle

after the 8

press.

Within 10 seconds of getting the jiggle, press and quickly release the "Learning Button" on the motion

sensor, the motor will jiggle again, motion sensor's LED will flash once. The motion sensor is now paired

to the motor.

Note: If the LED flashes several times, you have held the learning button for too long and sent a

delete command instead. Repeat the step above and make sure to only give the learning button a

quick press and release.

Page 1.

Back Mount