- ページ 3

アダプター Alpha Networks Extreme WUS-ND12AのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Alpha Networks Extreme WUS-ND12A 7 ページ。 802.11a/b/g/n usb module

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the

antenna and users, and

2) The transmitter module may not be co-located with any other transmitter

or antenna.

As long as 2 conditions above are met, further transmitter test will not be

required. However, the OEM integrator is still responsible for testing their

end-product for any additional compliance requirements required with this

module installed

IMPORTANT NOTE: In the event that these conditions can not be met (for

example certain laptop configurations or co-location with another transmitter),

then the FCC authorization is no longer considered valid and the FCC ID can

not be used on the final product. In these circumstances, the OEM integrator

will be responsible for re-evaluating the end product (including the transmitter)

and obtaining a separate FCC authorization.

End Product Labeling

This transmitter module is authorized only for use in device where the antenna

may be installed such that 20 cm may be maintained between the antenna and

users. The final end product must be labeled in a visible area with the

following: "Contains FCC ID: RRK-WUSND12A". The grantee's FCC ID can

be used only when all FCC compliance requirements are met.

Manual Information To the End User

The OEM integrator has to be aware not to provide information to the end user

regarding how to install or remove this RF module in the user's manual of the

end product which integrates this module.

The end user manual shall include all required regulatory information/warning

as show in this manual.