- ページ 11

メディア・コンバーター Axis M7016のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Axis M7016 15 ページ。 Video encoder

AXIS M7016 Video Encoder

RS485/RS422 TX A

RS485/RS422 TX B

Install the Hardware

Mount the video encoder

The AXIS M7016 is supplied with a mounting kit containing brackets. The unit can be mounted in

a rack or on a wall.

After removing the existing 4 screws, attach the mounting brackets to the video encoder at an

angle suitable for installation in a standard 1U 19" rack, or on the wall.

Mounting on a wall

1. Position the video encoder against the wall with the brackets attached, and mark the

four mounting holes, two for each bracket.

2. Drill the four mounting holes.

3. Attach the video encoder to the wall using appropriate screws.

Connect the cables

1. Connect the video encoder to the network using a network cable RJ45.

2. Connect the cameras to the video inputs.

3. Connect the supplied indoor power adapter.

4. Check that the indicator LEDs indicate the correct conditions. See LED Indicators, on

page 8

Use the tools provided on the Installation and Management Software CD to assign an IP address,

set the password and access the video stream. This information is also available from the support

pages on www.axis.com/techsup/

Important

Reset to factory default should be used with caution. A reset to factory default will reset

all settings, including the IP address, to the factory default values.

To reset the product to the factory default settings:

(TX) For full duplex RS485/RS422