- ページ 3

サンダー Alpha Professional Tools VDP-714のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Alpha Professional Tools VDP-714 16 ページ。 Variable speed rotary polisher

SPECIFICATIONS

11.0A
120 Volts
5.4A
230 Volts

INTRODUCTION

Thank you for purchasing the Alpha
VDP-714 Variable Speed Rotary Polisher. Please read
this instruction manual thoroughly to ensure safe and
correct use of the rotary polisher. Keep this manual in
a place where operators can access it easily whenever
necessary.
ABOUT THE SYMBOLS
According to the hazard level, all safety notes in this
manual are classified into "DANGER", "WARNING"
and "CAUTION".
DANGER! - Death or serious personal injury is
imminent when handling this polisher incorrectly.
WARNING! - There is a possibility of death or serious
personal injury when handling this polisher incorrectly.
CAUTION! - There is a possibility of personal injury or
property damage when handling this polisher incorrectly.
NOTE: In some situations, failure to observe
WARNING notes could result in death or serious
personal injury. Be sure to read and observe the
safety notes to ensure safety and correct use of the
electric wet/dry stone cutter
SAFETY INSTRUCTIONS FOR POWER
TOOLS
1. Know Your Power Tool. Read owner's
manual carefully. Learn its applications and limita-
tions as well as specific potential hazards particular
to this tool.
2. Keep Work Area Clean. Cluttered areas and
benches invite accidents.
3. Avoid Dangerous Environments. Keep
work areas as dry as possible. Do not use tool in
presence of flammable liquids or gases. Keep the
area well lit.
4. Keep Children and Visitors Away. All
visitors should be kept a safe distance from the work
area. Keep out of reach of children.
Single-
700~3500
phase AC,
RPM
50/60Hz
VDP-700 /
®
.
1250W
A(120V)
C(230V)
5. Don't Force Tool. It will do the job better and
safer at the rate for which it was designed.
6. Wear Proper Apparel. Do not wear loose cloth-
ing or jewelry as it can get caught in moving parts.
Rubber gloves and insulated non-skid footwear
are recommended. Wear protective covering to
contain long hair.
7. Wear Proper Eye Protection. All users and
bystanders must always wear proper personal eye
protection which conform with ANSI/ISEA Z87.1
(CAN/CSA Z94.3). Also, use a face or dust mask
if operation is dusty. Always wear certified safety
equipment.
8. Wear Proper Ear Protection. All users and
bystanders must wear proper personal ear protection
which conforms with ANSI S12.6 (S3.19) hearing
protection.
9. Wear Proper Respiratory Protection. All
users and bystanders must wear proper personal
respiratory protection. Always use NIOSH/OSHA
approved respiratory protection appropriate for the
dust exposure.
WARNING! Some dust created by power
sanding, sawing, grinding, drilling, polishing and
other construction activities contains chemicals
known to the State of California to cause cancer,
birth defects, or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other
masonry products, and
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depend-
ing on how often you do this type of work. To
reduce your exposure, work in a well venti-
lated area, and work with approved safety equip-
6.4 lbs
9"
(VDP-700)
2.9 kgs
(228mm)
(VDP-714)
Spindle

English

5/8"-11
Spindle
M14-2
3