- ページ 5
バッテリーチャージャー DieHard 200.713201のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DieHard 200.713201 16 ページ。 20/15/10/2 amp fully automatic battery charger
DieHard 200.713201 にも： オーナーズマニュアル (16 ページ)
ページを印刷する
BEFORE USING YOUR BATTERY CHARGER
It is important to understand your charger's requirements. This section will tell you
about your charger's electrical requirements and how to prepare a battery for
charging.
ASSEMBLING YOUR CHARGER
Included with your battery charger are
two cord wrap posts for storage of the
clamp cables.
To install, align the three tabs to
correspond with the three receptacles
and push until you hear a snap.
Wrap clamp cord after unplugging the
power cord and store your charger in a
dry location.
PLUGGING IT IN
WARNING: Electrical Shock Hazard.
Be sure that the power cord fits properly
into the outlet. If not, have a qualified
technician install a proper outlet. Never
alter the AC cord or plug provided.
Improper connection can result in
electrical shock.
Your charger requires a 120V receptacle
installed according to all local codes and
ordinances.
USING AN EXTENSION CORD
The use of an extension cord is not
recommended. If you must use an
extension cord, please make sure
that you follow these guidelines:
• Make sure that the pins on charger's
power cord fit firmly into the extension
cord, and that the extension cord fits
firmly into the receptacle.
• Check that the extension cord is
properly wired and in good electrical
condition.
• Make sure that the wire size is large
enough for its length and for the AC
ampere rating as specified in the chart
below.
MINIMUM RECOMMENDED EXTENSION CORD
Length of Cord, in Feet
AWG* Size of Cord
*AWG=American Wire Gauge
5
Cord Wrap Cleat
25 50 100 150
18 16 12
10