- ページ 8
リモートスターター DieHard Portable Power 950のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DieHard Portable Power 950 9 ページ。 12v dc power source and jump starter
DieHard Portable Power 950 にも： 取扱説明書 (9 ページ), オーナーズマニュアル (9 ページ), 取扱説明書 (13 ページ), 取扱説明書 (7 ページ)
ページを印刷する
9.5
Remove the negative (first) and positive nuts and bolts securing the cable
to the battery.
9.6
Push cables to the side and carefully slide battery out of the 950.
9.7
Reverse steps for assembly. Make sure that the nuts and bolts securing
the cables are tight.
10.1
IMPORTANT:
CHARGE IMMEDIATELY AFTER PURCHASE
KEEP FULLY CHARGED.
Charge the 950 internal battery immediately upon purchase, every 30
days and after every use.
All batteries are affected by temperature.
The ideal storage temperature is
between 40 and 70 degrees Fahrenheit. The internal battery will gradually
self-discharge
(lose power) over time, and more quickly in warm environ-
ments. Leaving the battery in a discharged state may result in permanent
battery damage. To ensure satisfactory performance and avoid permanent
damage, charge the internal battery every month.
When the JUMP START ON/OFF switch is ON, the clamps are live and
will produce arcing or sparking if they come in contact with each other. To
prevent accidental arcing, always keep the clamps on the storage holders
and the JUMP START ON/OFF switch in the OFF position when not using
it to jump start a vehicle.
Replacing
the built-in
light
To replace the built-in light bulb:
1. Turn the light off.
2. Insert a standard (flat-blade) screwdriver into one of the two slots along
the bottom of the plastic tens and GENTLY pop the tens out. Repeat for
the other side.
3. Insert a replacement
bulb of the same type and rating, and twist clock-
wise one quarter-turn to screw in the new bulb.
4. Replace the tens cover.
5. Test the light by switching the light on and off.
10.2
Customer Technical Assistance
Customer technical assistance is available Monday-Friday,
7 am to 4:30
pm Central Time by phoning 1-800-SEARS-64.
,6,