- ページ 5

自動車バッテリー充電器 DieHard 200.71230のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DieHard 200.71230 14 ページ。 Battery charger 40/2 amp manual 200 amp engine starter
DieHard 200.71230 にも：取扱説明書 (20 ページ), オーナーズマニュアル (14 ページ)

ページを印刷する

Before Using Your Battery Charger

It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground

and connect the power cord, and prepare to charge a battery.

Assembling

your charger

It is important to fully assemble your charger before use.

Follow these instructions for easy assembly.

PARTS:

Two 10-32 thread cutting

screws

Two 1/4-20 thread cutting

screws

Two wheels

One axle

Two axle caps

Two axle brackets

One handle

One mounting foot

TOOLS NEEDED:

3/8" wrench

(for mounting foot)

5/16" wrench

(for wheels)

Hammer

Phillips screwdriver

To attach the axle assembly:

Remove charger from packing materials and place

upside down on a flat surface. Attach mounting

foot and secure with the two 1/4-20 thread cutting

screws.

Hold axle upright on floor or work surface. Then,

using a hammer, tap one of the plastic hubs onto

the top end of the axle. Be sure to tap the hub on

straight. Slide both wheels onto the axle with the

hubs facing inward.

continued on next page