- ページ 6
自動車バッテリー充電器 DieHard Portable Power 950のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DieHard Portable Power 950 7 ページ。 12v dc power source and jump starter
DieHard Portable Power 950 にも： 取扱説明書 (9 ページ), 取扱説明書 (9 ページ), オーナーズマニュアル (9 ページ), 取扱説明書 (13 ページ)
ページを印刷する
USING THE AIR COMPRESSOR
WARNING: Read the instructions of the
product being inflated before using the
compressor. Avoid overinflation; do not
exceed the manufacturer's recommended
pressures. Do not leave the air compressor
unattended during use.
1. Ensure the battery clamps are securely on
the storage holders.
2. Remove the air compressor hose from the
storage compartment in the back of the
Portable Power.
3. Attach the air compressor hose to the
product or accessory to be inflated by
flipping down the lever.
4. Place the compressor switch in the ON
position and inflate the product.
5. When the product is inflated to the proper
air pressure (using the air compressor
gauge) place the compressor switch in the
• Clean the clamps and the case each time
you are finished using it.
• Recharge the unit once a month when not
in use.
PROBLEM
The Portable Power won't
jump start my car.
MAINTENANCE AND CARE
• Store clamps on their support posts, to
• Never completely discharge the internal
TROUBLESHOOTING
POSSIBLE CAUSE
Clamps are not making
a good connection to the
battery.
Connections are reversed.
The Portable Power's battery
is not charged.
The vehicle's battery is
defective.
The Portable Power is not
turned on.
6
•
•
OFF position and remove the hose.
6. Do not run for more than 10 minutes
maximum at a time. Allow the Portable
Power to cool down for 10 minutes before
using again.
NOTE: To prevent overheating, the
compressor has built-in thermal protection
that will turn the compressor off before it
overheats. If the compressor shuts off, wait
a few minutes and it will automatically
restart when the compressor cools.
NOTE: The air compressor is rated for
150 PSI.
ESTIMATED TIME FOR INFLATING
Vehicle Tires 13"-16"
Bike Tires
Sports Balls
These times are approximate. Use the air compressor
gauge to ensure the proper pressure has been reached.
Do not overinflate.
ensure they do not come into contact with
any metallic surface.
battery.
REASON/SOLUTION
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the Portable Power
and reverse the clamps.
Press the Battery Status
button on the front of the unit.
The LEDs will indicate the
status of charge.
Have the battery checked.
Turn the jump start ON/OFF
switch to the ON position.
5-8 minutes
1-3 minutes
30 seconds