- ページ 5

デジタルカメラ Olympus Camedia C-2500LのPDF 追加機能をオンラインで閲覧またはダウンロードできます。Olympus Camedia C-2500L 33 ページ。 External flash or strobes not firing with olympus cameras
Olympus Camedia C-2500L にも：パンフレット＆スペック (9 ページ), パンフレット＆スペック (2 ページ), トラブルシューティング (3 ページ)

ページを印刷する

Exposure Compensation

P MODE

A MODE

In the P and A modes, you can compensate exposure to ±2EV in 1/3 EV steps.

"P" / "A"

Setting Aperture

A MODE

M MODE

By setting the aperture manually, you can take sharp pictures from foreground to background or with the foreground and back-

ground deliberately out-of-focus.

"A" / "M"

Set the mode dial to "P" or "A".

While holding down the [+/-] button, set the exposure compen-

sation with the right / left point of the jog dial.

Pressing the right point of the jog dial with the [+/-] button held down

increases (+) compensation.

Pressing the left point of the jog dial with the [+/-] button held down

increases (-) compensation.

Exposure compensation will be displayed on the control panel. A

tone is emitted when either the highest or lowest value of the expo-

sure compensation is reached.

Once the exposure compensation is decided, press the shutter

release button down halfway.

The green lamp inside the viewfinder will light up to indicate the cam-

era is ready to take the picture.

Press the shutter release button down all the way.

MEMO

• The flash light is not compensated automatically. See P. 47 about

how to change the amount of the flash light.

NOTE

• If exposure is compensated in the positive direction when the flash is

used, the shutter speed will be reduced in order to expose the back-

ground more clearly. In this case, hold the camera firmly to avoid pic-

ture blur.

• The selected exposure compensation value is stored in memory

although the power is switched off. Check the value when turning on

the camera again.

Set the mode dial to "A" or "M".

Use the left point of the jog dial to set the aperture at

the right point to set the aperture at

Press the shutter release button down halfway to lock the focus.

The green lamp inside the viewfinder will light up to indicate the cam-

era is ready to take the picture.

The exposure level will be displayed on the control panel when you

are in the M mode.

If exposure is off by more than ±2 EV, a triangle blinks on the panel.

If metering is impossible, the entire exposure indications blinks.

Press the shutter release button down all the way.

MEMO

• Aperture has varying values in the TELE and the WIDE modes.

Triangle

NOTE

• If the aperture is set at

areas where there is a bright object (e.g., reflected sunlight). This

phenomenon is a normal characteristic of the CCD. Should this hap-

pen, set the aperture to

WIDE

TELE

F2.8

F3.9

F5.6

F7.8

, smear may occur in the picture frame in

and

E-33