- ページ 4

デジタルカメラ Olympus DP71のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus DP71 32 ページ。 Microscope digital camera
Olympus DP71 にも：取扱説明書 (32 ページ)

IMPORTANT

The DP71 microscope digital camera is designed to be connected to a camera adapter mounted on an

Olympus UIS2/UIS series of optical microscope for use in recording of microscopic magnified images at

high speed (about 3 seconds) and highest resolution while maintaining high picture quality and high

color reproduction. The DP71 incorporates a variety of functions for supporting image recording under

optimum conditions.

When the DP71 microscope digital camera is used with a camera adapter or a microscope from other

manufacturer than Olympus, the optical performance may not be manifested fully.

CAUTION

Never connect or disconnect the interface cable while the main switch of the computer is set to " " (ON).

Otherwise, malfunction may result.

1. Before connecting or disconnecting the interface cable, make sure that the main switch of the computer is set to "

(OFF).

When connecting the interface cable, tighten firmly the lock screws on it and ensure that the connector will not slip out

before setting the main switch to "

2. The cords and cables are vulnerable to bend or twist. Do not apply excessive force to them.

3. To prevent the microscope from toppling down, avoid using microscope attachments that may make the total height of

the microscope above 1 meter when they are attached.

4. When installing the PCI interface board, be sure to hold it by the edge. Never touch the board surface directly, as this will

lead to malfunction.

The PCI interface board area shown in the illustration on

the right becomes very hot during and immediately after

use of the camera. Be careful never to touch them during

and after use.

5. Connect the provided power cord correctly and ensure that the

grounding terminal of the power supply and wall outlet are

properly connected. If the equipment is not grounded/earthed,

Olympus can no longer warrant the electrical safety performance

of the equipment.

6. Lay out the interface cable so that it does not contact the heat

generating section such as the lamp housing of the microscope.

" (ON).

Hot part