- ページ 14

デジタルカメラ Olympus E-3のPDF よくある質問をオンラインで閲覧またはダウンロードできます。Olympus E-3 26 ページ。 E-3 guide de démarrage rapide (français)
Olympus E-3 にも：クイック・スタート・マニュアル (2 ページ), システムチャート (1 ページ), ユーザーマニュアル (17 ページ), 仕様 (6 ページ), 仕様 (3 ページ), (クイック・スタート・ガイド (2 ページ), (フランス語）クイック・スタート・ガイド (2 ページ)

ページを印刷する

•

S-AF+MF (Simultaneous use of the S-AF and Manual Focus) – This mode allows

the photographer the option of fine adjusting the focus using the lens focus ring

after the shutter button has been pressed halfway and autofocus has been

locked. This mode allows the photographer more creative control over the

autofocus to focus on a specific area the autofocus may not have selected.

•

C-AF+MF (Simultaneous use of the C-AF and Manual Focus) – This mode allows

the photographer to manually focus before pressing the shutter button halfway to

enable C-AF. It allows the photographer to pre-focus the lens closer to a focus

zone to provide the autofocus with a more rapid response in situations such as

sports or wildlife photography.

The subject I want in focus doesn't line up with any of the AF frames

in the viewfinder. How do I get the camera to focus on the subject?

The Focus Lock function enables the photographer to prefocus on a specific subject,

lock the focus, and then re-compose the image and shoot the picture.

1. Position the AF frame on the autofocus subject and press the shutter button

halfway until the AF confirmation mark lights up. The focus will be locked.

2. While holding the shutter button in the halfway position, recompose the image

and press the shutter button all the way to shoot the picture.

At first this may seem cumbersome, but with practice it can become a fluid movement.

What is the difference between NORMAL and SMALL AF SENSITIVITY?

NORMAL AF SENSITIVITY is used for most shooting situations. At this setting, the

camera focuses within the selected AF area and on the surrounding area. SMALL AF

SENSITVITY focuses only within the selected AF area. This setting can be useful in

situations such as wildlife photography where it is necessary to photograph animals

through tree branches in the foreground. Using a more precise AF area will reduce the

chance of the autofocus system becoming confused by the branches.

Is there a way to shoot if I don't want to wait for autofocus to lock

or the flash to recycle?

Normally, the E-3 will not shoot while autofocus is operating or the flash is charging.

However, situations may arise where the photographer would want to override the

camera and force it to fire under marginal shooting conditions when the camera may not

be ready to shoot.

The Shutter Release Priority function will permit the camera to shoot even though

normal shooting requirements are not met. The function is found in the

menu under Custom Menu 1. Two options are available:

•

RLS PRORITY S: Set to ON to enable the camera to fire immediately, without

waiting for focus confirmation, in the S+AF autofocus mode.

•

RLS PRIORITY C: Set to OFF to force the camera to secure focus before firing

in the C+AF autofocus mode. Predictive AF is not available for the first shot

when this function is enabled.

Be advised that overriding the camera creates special considerations. Shooting before

the flash has recycled may cause images to be underexposed if ambient light is

insufficient to illuminate the subject. Shooting before autofocus has locked may result in

blurry images, particularly when the subject is in motion. To compensate for the loss of

autofocus, increase the depth of field by shooting with the smallest aperture that is

practical for acquiring the shot.

Page 14 of 26

D I G I T A L T E C H N I C A L S U P P O R T

O L Y M P U S I M A G I N G A M E R I C A I N C .

( 8 8 8 ) 5 5 3 - 4 4 4 8

h t t p : / / s u p p o r t . o l y m p u s a m e r i c a . c o m

Last updated on February 28, 2008