- ページ 15

顕微鏡 Olympus BHSUのPDF 完全な分解、洗浄、再組み立てをオンラインで閲覧またはダウンロードできます。Olympus BHSU 19 ページ。 Reverse nosepiece

ページを印刷する

Apply Grease to the Mechanical Detents

Apply fresh grease (item 8 of

mechanical detent notches in the revolving turret (see

Figure

41).

Be careful that you do not get grease

anywhere else.

Figure 41 – Apply grease to the five detent notches

Reinstall the Protective Cover

Place the protective cover into position on the back side

of the turret assembly, lining up the three holes in the

protective cover with the tapped holes in the stationary

base (see

Figure

42).

Figure 42 – Place cover in position on the turret assembly

Use a suitable JIS screwdriver to reinstall three M2X3

countersink screws to secure the protective cover onto

the stationary base (see

Complete Teardown, Cleaning, and Reassembly of the Olympus BHSU/BHTU Reverse Nosepiece Assembly

Appendix

1) to the five

Figure

43).

Figure 43 – Secure protective cover using three screws

Reinstall the Knurled-Rubber Grip Ring

The final assembly step for the turret assembly is to

reinstall the black knurled-rubber grip ring around the

outer perimeter of the revolving turret and secure it in

place with a suitable color-matching adhesive. Black

silicone RTV is a good choice of adhesive here, since it

will bond well with the metal of the revolving turret as

well as to the black knurled-rubber grip ring.

Additionally, any of the inevitable squeeze-out that is

not removed will not be visible. Apply two dabs of black

silicone RTV (item 7 of

perimeter of the revolving turret, spaced approximately

180° apart (see

Figure

44).

Figure 44 – Apply black silicone RTV to revolving turret

Carefully reinstall the knurled-rubber grip ring onto the

outer perimeter of the revolving turret, making sure to

not stretch or damage the grip ring (see

Appendix

1) onto the outer

Figure

45).

Revision 3

Page 15 of 19