- ページ 3

顕微鏡 Olympus CH40のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus CH40 28 ページ。 Biological microscope
Olympus CH40 にも：取扱説明書 (29 ページ)

ページを印刷する

€

Getting Ready

1 . A microscope is a precision instrument. Handle i t with care

'and avoid subjecting i t to sudden or severe impact.

2 . Do not use the microscope where i t is subjected to direct

sunlight, high temperature and humidity, dust or vibrations.

(For operating environment conditions, refer to and adhere to

the conditions specified in Section 6, SPECIFICATIONS on

page 16)

3 . The tension ofthe coarse focus adjustment knob should only

be adjusted by means of the tension adjustment ring,

4 . Heat from this microscope is lod away by natural convection,

Consequenti, do not use itina constricted space and ensure

that the room is well ventilated,

5 . When moving the microscope, carry i t with one hand under

the base D and the other hand holding at the recessed handle

'on the rear of the arm @ as shown in the illustration on the

left. Handle the microscope with care when moving i t

* When moving the microscope, never hold the stage or

binocular section of the observation tube, etc. Also

make sure that eyepieces, specimen, etc. do not falloff.

* Sliding the microscope on the surface of the table may

Faz

damage or tear off the rubber feet and/or scratch the

table top surface.

1 . Clean all glass components

by wiping gently with gauze. To remove fingerprints or oil smudges, wipe with gauze

slightly moistened with a mixture of ether (70%) and alcohol (80%)

* Do not use a mixture of ether (70%) and alcohol (30%) to clean the lower lens (made of optical plastic) of

the eyepiece (NCWHK10X) because such solvents cloud the lens. If dust adheres to the lens, blow i t off

or wipe i t away gently with a dry cloth.

'Since solvents such as ether and alcohol are highly flammable, they must be handled carefully. Be sure

to keep these chemicals away from open flames or potential sources

of electrical sparks — for example,

electrical equipment that is being switched on or off, Also remember to always use these chemicals

only in @ well-ventilated room.

2 . Do not attempt to use organic solvents to clean the non-optical components of the microscope. To clean these,

use a lint-free, soft cloth lightly moistened with a diluted neutral detergent.

2. Do not disassemble any part of the microscope as malfunction or damage may occur

4, When not using the microscope, keep i t covered with the provided dust cover.

Warning Labels

Warning labels are affixed at parts where special precaution is required when handling and using the microscope,

Always heed the warnings,

[Caution for

Warning Label Position | Base Underside

"gay

po car

If warning labels become soiled, peel off, etc. contact your local Olympus representative to have them replaced.

€

I the microscope is operated in a manner not specified by this manual, the safety of the user may be imperiled. In

'addition, the equipment may also be damaged. Always operate the equipment as outlined in this instruction manual