- ページ 24

顕微鏡 Olympus CX23のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus CX23 32 ページ。 Biological microscope

Assembly

Connecting the AC adapter and power cord

· Always use the AC adapter and power cord provided by

CAUTION

Olympus. If the proper AC adapter and power cord are

not used, the electric safety and EMC performance of the

device can not be assured. If no power cord is provided,

please select the proper power cord by referring to the

section"Proper selection of the power supply cord" at the

end of this instruction manual.

· The power cord and AC adapter cord are vulnerable when

bent or twisted. Never subject them to excessive force.

· Make sure that the main switch a is set to "

before connecting the power cord.

Connect the output connector b of the AC adapter to the input

connector c on the rear of the microscope.

Do not tilt the microscope to the rear, since doing so

CAUTION

could damage the output connector b .

Connect the power cord's connector d to connector e firmly.

Connect the power cord's plug f to a wall power outlet g .

Storing the AC adapter and power cord

Make sure that the main switch a is set to "

CAUTION

before storing the power cord.

Unplug the power cord's plug from a wall power outlet.

Disconnect the output connector b of the AC adapter from the input

connector c on the rear of the microscope.

Bundle the AC adapter cord e as shown in the picture on the left,

and store it in the space at the bottom of the microscope together with

the AC adapter itself f . In this case, remove the cable tie attached

to the AC adapter cord e before storing.

After the AC adapter cord e and the AC adapter f are stored, insert

the output connector b of the AC adapter into the input connector c .

Bundle the power cords d and store them on the rear of the

microscope.

} If you use the kensington lock, insert the AC adapter to the

microscope frame upside down.

" (OFF)