- ページ 4

顕微鏡 Olympus CX41のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus CX41 32 ページ。 System microscope
Olympus CX41 にも：概要 (7 ページ), インストラクション (32 ページ)

ページを印刷する

IMPORTANT

This microscope employs a UIS (Universal Infinity System) optical design, and should be used only with UIS

eyepieces, objectives and condensers, etc. (Other modules described on page 21 may also be usable with this

microscope. For details, please consult Olympus or the catalogue.) Less than optimum performance may result if

inappropriate accessories are used.

SAFETY PRECAUTIONS

Fig. 1

1. After the equipment has been used in an observation of a specimen

that is accompanied with a potential of infection, clean the parts

coming in contact with the specimen to prevent infection.

Moving this product is accompanied with the risk of dropping the

{

specimen. Be sure to remove the specimen before moving this

product.

In case the specimen is damaged by erroneous operation, promptly

{

take the infection prevention measures.

The product becomes unstable if its height is increased by an

{

accessory mounted on it. In this case, take anti-topping measures to

prevent the specimen from being dropped when the product topples

down.

2. To avoid potential shock hazard and fire, always set the main switch @

to "

" (OFF) and disconnect the power cord from the AC receptacle

at the rear of the microscope and from the wall outlet before replacing

the bulb. Allow the lamp housing cover ² and the bulb to cool before

touching them.

3. Install the microscope on a sturdy, level table.

The air vents on the underside of the base should never be blocked

by placing the microscope on a flexible surface such as a carpet, as

this could result in overheating and cause a fire.

4. Always use the power cord provided by Olympus. If no power cord is

provided, please select the proper power cord by referring to the

section "PROPER SELECTION OF THE POWER SUPPLY CORD" at the

end of this instruction manual. If the proper power cord is not used,

Olympus can no longer warrant the electrical safety and performance

of the equipment.

5. When installing the microscope, route the power cord away from the

microscope base. Should the power cord come in contact with the hot

microscope base, the power cord could melt and cause electric shock.

6. Connect the power cord correctly and ensure that the grounding

terminal of the power supply and that of the wall outlet are properly

connected. If the equipment is not grounded, Olympus can no longer

warrant the electrical safety and performance of the equipment.

7. Never set the main switch @ to "

inserted into the air vents of the microscope frame as this will result in

electrical shock, personal injury and equipment damage.

8. When the microscope is not in use or when it is malfunctioning,

disconnect the power cord plug from the AC receptacle or from the

wall outlet.

" (ON) while any metallic object is