- ページ 23

顕微鏡 Olympus U-MDO10R3のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus U-MDO10R3 40 ページ。 For 2, 5, 9, 10 and 13 persons

Attaching the side viewer

Remove the cap on the observation attachment body a and the cap

from the mount b on the side viewer.

Return the vertical direction of the side viewer where the stand is

attached to the original direction. Insert b of the side viewer into the

observation attachment body a completely to the end.

While holding the base c of the stand firmly with your hand, rotate

the mount ring d to secure the side viewer to the observation

attachment body.

After the mount ring d is rotated completely, make sure

NOTE

that the stand is installed on the desk securely. Insert a

sheet of paper between the base of the stand and the

desk. If the paper touches three rubber legs, the stand is

installed securely. If the paper does not touch even one

rubber leg, perform

Attach the observation tube b for the main observer to the tube mount

a on the observation attachment body at the main observer position,

and tighten the clamping screw c to secure the observation tube.

Attach the observation tube so that the side surface d of the

TIP

observation attachment body is parallel to the side surface

attached in the proper direction, the orientation of the image

observed by assistant observers differs from that observed by

the main observer. (For the orientation of the observed image,

see "1 Configuration of the discussion system and orientation

of observed images" (page 5).

again.

e of the observation tube. If the observation tube is not