- ページ 12

カメラアクセサリー Olympus PFL-E01のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PFL-E01 29 ページ。 Electronic flash waterproof case for the fl-36

Check the orientation of the cable's 5-pin plug and insert it into the TTL connector's 5-

pin jack on the Case. To facilitate insertion, align the marking on the cable's connector

with the marking on the Case's TTL cable connector.

Turn the connector lock dial on the Case all the way to lock the connection firmly.

To disconnect the underwater TTL cable, reverse the connection procedure. After

disconnecting the cable, screw the TTL cable connector cap back on the Case. Make

sure it is screwed on tightly.

Lock dial screw

CAUTION

：• Always make sure that the case are completely dry before connecting or

disconnecting the underwater TTL cable.

• O-rings are attached to the case's TTL connector caps and the underwater

TTL cable's connectors to keep out water. If any fibers, sand or hair are

attached to an O-ring, the integrity of the waterproof function will be affected

and water penetration may result. Be sure to check and remove any foreign

matter on the O-rings before connecting these connectors.

• Pay attention to the position of the 5 pins when connecting the connectors.

• Do not use excessive force when tightening the lock dial screw on the

cable's connector.

• When the underwater TTL cable is not connected, be sure to put the caps

back on the TTL cable connectors.

Use this mark to

align the position.

E-10