- ページ 37

カメラアクセサリー Olympus PT-034のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-034 44 ページ。 For the digital camera stylus 750/740, µ 750/740

Case under direct sunlight. Exposure to high temperatures or direct

sunlight may cause deformation, discoloration or breakage of the Case

and deterioration of the O-ring. Wipe the inside of the Case with a soft

cloth not causing any fibers. Remove the O-ring, wipe off any salt, sand,

dust, etc., and also clean the O-ring groove and the O-ring contact

surface in the same way and then dry them. When an object with a

sharp tip is used to remove the O-ring from the groove, the O-ring may

be damaged and water leakage may be caused. Always use the

provided O-ring remover.

Q6 : How should I take pictures under water?

A6 : Please observe the following items for shooting under water.

(1) Fix the protector with the accessory hand strap to your wrist.

(2) When you place a finger onto the lens window, the finger will appear

in the photo. Pay attention to the position of your fingers when

holding the Case.

(3) When pressing the shutter lever, hold the Case securely with both

hands and operate the lever quietly to prevent camera shake.

(4) Check the image you want to shoot by viewing the digital camera's

LCD monitor through the Case's LCD monitor window, and start

shooting.

To avoid interruption of shooting due to battery depletion, it is

recommended to replace the existing battery with a fully charged

battery before diving.

Q7 : can I check for water leakage?

A7 : For confirmation, perform the advance test and the final test after

loading the camera. The advance test with immersing the Case

without the camera to the intended use depth to check for water

leakage is the most accurate test, but when this is difficult, it is safer

to perform this test even at a depth of 1 m or in a bathtub. The final

test also can be performed in a bathtub or a bucket.

Q8 : What are the causes for entry of water?

A8 : The main causes for the entry of water are shown below. Please

check them most carefully.

(1) Forgetting to install the O-ring

(2) The O-ring is partly or completely outside the groove.

(3) Damage, deterioration, or deformation of the O-ring

(4) Sand, fibers, hair or other foreign matter on the O-ring

(5) Sand, fibers, hair or other foreign matter on the O-ring groove or the

O-ring contact surface

E-36