- ページ 31

カメラアクセサリー Olympus PT-044のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-044 35 ページ。 Underwater case for digital camera fe-360; x-875; c-570

Install the O-ring

Confirm that no foreign matter is adhered, apply a thin coat of the grease

provided to the O-ring, and fit the O-ring into the groove. At this point,

confirm that the O-ring does not stick out from the groove.

Apply the exclusive

lubricant to each O-

ring.

Spread the lubricant

all over the O-ring.

Check that the O-ring

is free of scratches or

unevenness.

Apply lubricant on the

O-ring contact

surface.

CAUTION:

• Always perform maintenance of the waterproof function even when the

Case has been opened to exchange the battery or the image storage

during shooting. Neglecting this maintenance may cause water leakage.

• When the Case is not to be used for a long time, remove the O-ring from

the groove to prevent deformation of the O-ring, apply a thin coat of silicone

grease, and store it in a clean plastic bag or the like.

• Drying the Case with salt adhered may impair the function. Always wash

off any salt after use.

Make sure that your fingers and the

O-ring are free of dirt, and squeeze about

5 mm of lubricant onto a finger. (5 mm is

the most appropriate amount.)

Apply the lubricant with three fingers and

spread it over the ring. Be careful not to

use force as this may stretch the O-ring.

After spreading the lubricant, check

visually and by touch that the O-ring is

not scratched and that its surface is flat.

If it is damaged in any way, be sure to

replace it with a brand-new O-ring.

Use the lubricant remaining on the

fingers to clean and lubricate the case's

contact surface.

EN 31