- ページ 33

カメラアクセサリー Olympus PT-E02のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-E02 41 ページ。 Underwater case for digital camera e-330

ページを印刷する

Install the O-ring.

Confirm that no foreign matter is attached, apply a thin coat of the accessory grease to the

O-ring, and fit the O-ring into the groove. At this time, confirm that the O-ring does not stick

out from the groove.

How to Apply Grease to the O-ring

Apply the exclusive

lubricant to each O-

ring.

Spread the

lubricant all over

the O-ring.

Check that the

O-ring is free of

scratch or

unevenness.

Apply lubricant on

the O-ring contact

surface.

CAUTION

: • Always perform maintenance of the waterproof function even when the

Case has been opened to exchange the battery or the image storage during

shooting. Neglecting this maintenance may become the cause of water

leakage.

• When the Case is not to be used for a long time, remove the O-ring from

the groove to prevent deformation of the O-ring, apply a thin coat of silicone

grease, and store it in a clean plastic bag or the like.

• When drying is done with salt attached, it is likely that a function impairment

will be caused. After use, always wash off any salt.

Replace consumable products.

• The O-ring is a consumable product. Independent of the number of times the Case is

used, it is recommended that the O-ring should be replaced by a new one at least once a

year.

• Deterioration of the O-ring is accelerated by the use conditions and the storage

conditions. Replace the O-ring even before a year has passed if it shows signs of

damage, cracking or loss of elasticity.

Note

Please use original Olympus products for the silicone O-ring grease, the silica

gel, and the O-ring. These consumable products also can be purchased at an

Olympus service station.

Make sure that your fingers and the O-

ring are free of dirt, and squeeze about 5

mm of lubricant onto a finger. (5 mm is

the most appropriate amount.)

Surround the lubricant with three fingers

and spread it over the ring. Be careful not

to use excessive force as this may

stretch the O-ring.

After spreading the lubricant, check visually

and by touch that the O-ring is not scratched

and that its surface is flat. If it is damaged in

any way, replace it with a brand-new O-ring.

Use the lubricant remaining on the

fingers to clean and lubricate the case's

contact surface.

E-31