- ページ 5

カメラアクセサリー Olympus PT-E02のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-E02 41 ページ。 Underwater case for digital camera e-330

Batteries

● Use an exclusive lithium-ion battery (Olympus BLM-1) designed for digital cameras.

● Keep the battery's contacts away from damp or humidity; otherwise this could impair

performance and/or cause accidents.

● For additional battery cautions, refer to your digital camera's instruction manual.

When water leakage occurs while this product is being used, repair of the camera housed in

this product may become impossible. Please observe the following cautions for use.

1. When sealing this product, make sure that no hairs, fibers, sand particles or other

foreign matter stick not only to the O-ring, but also to the contact surface. Even a single

hair or a single grain of sand may cause water leakage. Please check with special care.

Examples for foreign matter sticking to the O-ring

2. The O-ring is a consumption product. Please replace it at least once a year by new one.

Also perform maintenance for every use.

3. Deterioration of the O-ring will progress according to the use conditions and the storage

conditions. Immediately replace the O-ring by a new one if it is damaged, shows cracks, or

has lost its elasticity.

4. At the time of O-ring maintenance, clean the inside of the O-ring groove and confirm the

absence of dirt, dust, sand, and other foreign matter.

5. Apply the specified silicone O-ring grease to the O-ring.

6. The waterproof function is not effective when the O-ring is not installed correctly. When

installing the O-ring, take care that it does not project from the groove and that it is not

twisted. Also, when sealing the Case, close the lid after confirming that the O-ring has

not come out of the groove.

7. This product is an airtight construction made of plastic (polycarbonate). When it is left for a

long time in a car, on a boat, at the beach, or at other places reaching a high temperature, or

when it is subjected for a long time to uneven external force, it may be deformed and the

waterproof function may be lost. Pay sufficient attention to temperature control. Also do not

place heavy objects onto the product during storage or transport, and avoid unreasonable

storage.

8. When the O-ring contact surface is pressed strongly from the outside of the Case, or

when the Case is twisted, the waterproof function may be lost. Take care not to exert

excessive force.

9. Please be sure to perform the advance test and the final test each time before using the

case.

10. If you should notice drops of water or other signs of water leakage while taking pictures,

immediately stop the dive, remove any water from the camera and the product, test

according to the item "Final check", and confirm whether leakage has occurred or not.

Hair

Fibers

E-3

Fibers