- ページ 10

カメラアクセサリー Olympus PT-E03のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-E03 41 ページ。 Underwater case for digital camera e-410/e-400

Install the Waterproof Port.

To enable the Case to be used underwater, the separately available Waterproof Port for the camera lens

must be installed on the Case. Align the Waterproof Port with the position where the camera lens will be

when the camera is loaded in the Case.

• Refer to the instruction manual provided with the Waterproof Port before attaching the Waterproof Port

to the Case.

• Apply the provided O-ring grease to the O-ring section of the Waterproof Port and the Waterproof Port

mounting thread on the Case.

• Screw the Waterproof Port into the Case by turning it clockwise all the way.

CAUTION:

The Case should not be used underwater at depths that exceed 40 meters. Even when the attached

underwater lens port or other equipment is able to withstand depths exceeding 40 meters, the Case itself

cannot be used at depths of more than 40 meters.

Attach the hand strap to the Case.

Hand strap

CAUTION:

• Be sure to install the hand strap correctly as shown above.

• Two hand strap rings are attached to the side of the Case, at the top and bottom of the palm grip. Before

using the Case, be sure to attach the ends of the strap to the two hand strap rings.

• OLYMPUS IMAGING CORP. shall bear no responsibility for damage caused by dropping the Case because

of incorrect installation of the hand strap.

EN 9

Waterproof Port mount thread

O-ring grease

Hand strap ring