- ページ 25

カメラアクセサリー Olympus PT-E03のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-E03 41 ページ。 Underwater case for digital camera e-410/e-400

Insert the silica gel

Before sealing the Case, be sure to insert the silica gel bag in the space between the bottom of the

camera table and the inner surface of the Case. This will prevent fogging. Insert the silica gel bag so that

the shorter edge is deeper.

CAUTION:

• Insert the silica gel bag as far as it will go at the specified location and with the specified orientation. If the

orientation is incorrect, the silica gel bag will get caught when the Case is sealed and water will leak into

the Case.

• If the bag is only inserted part of the way, it will get caught by the O-ring when you try to seal the Case and

water will leak into the Case.

• Once silica gel has been used, the moisture absorption performance will be impaired. Always change the

silica gel when you open or close the Case.

Always perform the following final checks before sealing the Case.

• Does the zoom dial operate properly?

• Is the silica gel inserted all the way at the specified position?

• Are the O-rings and the O-ring contact surfaces free of dirt and other foreign matter?

• Are the O-rings installed properly?

• Is the Waterproof Port attached correctly?

• Is the TTL cable connector cap attached properly without loosening?

• Can the camera power be switched ON/OFF?

• Is the mode dial of the camera controllable?

• When using an external electronic flash, check that the hot shoe cable is connected properly and that

the camera's automatic pop-up setting is set to OFF.

• When using a slave-emission type underwater flash from a manufacturer other than Olympus, check

that the camera's built-in flash is popped up.

Pay attention to the orientation.

EN 24