- ページ 14

カメラアクセサリー Olympus PT-E05のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-E05 42 ページ。 Underwater case for digital camera e-520

CAUTION:

If the TTL cable connector cap is loose, water penetration may result. Be sure to gently turn the cap until it

stops to make sure it is firmly secured.

Do not turn or tighten the TTL cable too hard. If it is too tight, it may be difficult to loosen and remove.

Cleaning the TTL connector

If the threaded sections of the TTL cable and TTL cable connector stick to each other, the cable may

disconnect from the connector. To prevent this, apply silicone grease, provided with this case to the

threaded sections.

For details, see "Maintenance of the TTL Connector Cap" (P. 34) of this manual.

CAUTION:

If you cannot disconnect the TTL cable, do not use force. Contact Olympus for support.

To perform TTL flash shooting using the Case, connect the hot shoe cable (optional) between the

connector on the Case and the digital camera's hot shoe.

1 Turn the hot shoe cable connector cap inside the case

counterclockwise to remove it.

2 Insert the connector of the hot shoe cable into the case's

connector and turn the connector screws all the way

clockwise to connect them firmly.

3 Insert the hot shoe on the hot shoe cable into the hot shoe

on the camera.

The hot shoe cover removed from the camera can be

stored in the camera table.

For details, see "How to attach the camera table to the

digital camera" (P. 19) of this manual.

4 When not using the hot shoe cable, attach the hot shoe

cable cap to the hot shoe cable connector inside the case

and turn the cap all the way clockwise to attach it firmly.

CAUTION:

Be sure to remove the camera from the case when inserting the connector of the hot shoe cable into the

case's connector.

EN 13