- ページ 25

カメラアクセサリー Olympus PT-E06のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus PT-E06 30 ページ。 Underwater camera case

Replace consumable products

• The O-ring is a consumable product. Independent of the number of times the Case is used, it is

recommended that the O-ring should be replaced by a new piece at least once a year.

• Deterioration of the O-ring is accelerated by the usage conditions and the storage conditions. Replace

the O-ring even before a year has passed if it shows signs of damage, cracking or loss of elasticity.

CAUTION:

• Please use genuine Olympus silicone grease, silica gel and O-ring.

• Do not try to replace the O-ring by yourself.

• We recommend to perform the check periodically.

Maintenance of the threaded sections on the TTL cable and TTL

cable connector

If the threaded sections used to connect the TTL cable to the TTL cable connector are not maintained

properly, salt and other seawater residue may adhere to the TTL cable and prevent it from being

disconnected.

After use in seawater, clean off any salt, sand, or other residue as soon as possible, then dry the

equipment thoroughly. Clean the threaded sections with a cotton swab and apply a thin, uniform layer of

silicone grease (provided with this case).

After removing the TTL connector cap from the Underwater Case, be sure to clean and grease the O-

ring.

Use the maintenance adapter to remove the O-ring unit from the TTL connector cap.

TTL connector cap

1 Insert the adapter by aligning its pin with the hole on

the cap.

2 Turn the adapter counterclockwise to remove the O-

ring unit.

3 After removing the O-ring attached to the O-ring unit,

clean the O-ring groove and apply silicone grease to

the O-ring. Then, re-attach the O-ring to the O-ring

unit.

* Reverse the removal procedure to re-attach the O-ring unit to the TTL connector cap.

Clean and apply silicone grease to these

sections.

Maintenance adapter

O-ring

EN 24