- ページ 14

ラボラトリー機器 Olympus U-AFA2M-VISのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Olympus U-AFA2M-VIS 24 ページ。 Active autofocusing unit

SYSTEM STARTUP PROCEDURE

}The system can be started using dedicated software (analySIS FIVE or MX2-BSW).

For details, refer to the instruction manual for the software.

Fig. 5

Installing the AF Control Board

# Be sure to set the main switch on the BX-UCB control box @ to "

(OFF) before proceeding to installing the U-AFA2M-CB AF control

board.

1. Loosen the six clamping knobs on the two option slot covers on the rear

of the BX-UCB and remove the covers and knobs.

}To stabilize the installation operation, attach two of the removed clamping

knobs on the AF control board ².

2. Insert the AF control board ² into the BX-UCB by aligning the orientation

of the connector inside the BX-UCB and that of the AF control board.

Push in the board along the board rails all the way so that the connector

is plugged in securely.

}A space of two board rails is required for installation. Use two adjacent

option slots on either the central or right.

3. Clamp the AF control board ² using the clamping knobs removed above.

Also attach the other removed cover ³ using the other clamping knobs

removed above.

}Store the other, unused option board cover in a safe place.

Assembling Other Modules

Mount all of the applicable modules selected by the user.

At the end, confirm that the main switches of the connected modules are

set to "

" (OFF) and connect the cables.