- ページ 6
ソウ Axminster MCB100AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axminster MCB100A 20 ページ。 4" metal cutting bandsaw
ページを印刷する
workpiece shift after it is cut in two.
c. Use jigs, fixture or a different tool for
unstable workpieces.
• Never cut more than one workpiece at a
time.
• Make sure the cut-off piece can move
sideways after it is cut off. Otherwise, it
could get wedged against the blade and
thrown violently.
• Make sure bystanders are clear of the
tool and workpiece. Keep them clear of
the area behind the saw where debris will
be thrown.
• Never turn your metal saw "ON" before
clearing everything except the workpiece
and related support devices off the able.
D. To avoid risk of hearing damage, war ear
plugs or muffs during extended period of
operation.
E. To avoid being suddenly pulled into the
blade.
1. Do not wear gloved.
2. Remove all jewelry and loose clothing.
3. Tie back long hair.
4. Roll long sleeves above the elbow.
F. To avoid injury from accidental starting,
always unplug saw before disconnecting
the guard, installing or removing any
blade, accessory or attachment, or
making any adjustment.
G. To avoid an electrical shock, make sure
your fingers do not touch the metal
prongs on the plug when inserting or
removing the plug to or from a live outlet.
H. Never put lubricants on the blade while it
is spinning.
I.
To avoid burns or other fire damage,
never use the saw near flammable liquids,
vapors or gases.
J. To avoid injury from unsafe accessories
use only accessories shown on the
recommended accessories list in this
manual.
Whenever saw is running
WARNING: Do not allow familiarity
(gained from frequent use of your
metal saw) to cause a careless
mistake. Always remember that a
careless fraction of a second is
enough to cause a severe injury.
1. Before actually cutting with the saw, let it
run for a while. If your saw makes an
unfamiliar
noise
excessively, stop immediately. Turn the
saw off. Unplug the saw. Do not restart
until finding and correcting the problem.
2. Never confine the piece being cut out.
Never hold it, clamp it, touch it, or use
length stops against it. It must be free to
move sideways. If confined, it could get
wedged against the blade and thrown
violently.
3. Avoid awkward hand positions where a
sudden slip could cause a hand to move
into the blade.
4. Let the blade reach full speed before
cutting.
5. Feed the saw into the workpiece only fast
enough to let the blade cut without
bogging down or binding.
6. Before freeing jammed material, release
switch and unplug the saw. Wait for all
moving parts to stop.
7. After finishing a cut, keep holding the
power head down, release the switch,
and wait for all moving parts to stop
before moving your hands.
WARNING: Read the following warning
labels found on the front of the saw.
or
if
it
vibrates