- ページ 7
ソウ Axminster UE-127DV1のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axminster UE-127DV1 16 ページ。 Portable band saw
ページを印刷する
F.
To avoid injury from accidental starting,
always unplug saw before
disconnecting the guard, installing or
removing any blade, accessory or
attachment, or making any adjustment.
G.
To avoid an electrical shock, make
sure your fingers do not touch the
metal prongs on the plug when
inserting or removing the plug to or
from a live outlet.
H.
Never put lubricants on the blade while
it is spinning.
I.
To avoid burns or other fire damage,
never use the saw near flammable
liquids, vapors or gases.
J.
To avoid injury from unsafe
accessories use only accessories
shown on the recommended
accessories list in this manual.
Whenever Saw is Running
WARNING: Do not allow familiarity (gained
from frequent use of your metal saw) to
cause a careless mistake. Always
remember that a careless fraction of a
second is enough to cause a severe injury.
1.
Before actually cutting with the saw, let it
run for a while. If your saw makes an
unfamiliar noise or if it vibrates excessively,
stop immediately. Turn the saw off. Unplug
the saw. Do not restart until finding and
correcting the problem.
2.
Never confine the piece being cut out.
Never hold it, clamp it, touch it, or use
length stops against it. It must be free to
move sideways. If confined, it could get
wedged against the blade and thrown
violently.
3.
Avoid awkward hand positions where a
sudden slip could cause a hand to move
into the blade.
4.
Let the blade reach full speed before
cutting.
5.
Feed the saw into the work piece only fast
enough to let the blade cut without bogging
down or binding.
6.
Before freeing jammed material, turn the
switch off and unplug the saw. Wait for all
moving parts to stop.
7.
After finishing a cut, keep holding the power
head down, release the switch, and wait for
all moving parts to stop before moving your
hands.
Read the following warning labels found on
the front of the saw.
˙ Keep hands out of saw blade path.
˙ Never cut anything freehand.
˙ Never reach behind or beneath blade.
˙ To avoid electric shock, do not expose to
rain.
˙ Tighten arbor screw and all clamps
before turning power on.
4. Power Supply
Motor Specifications
The DC motor is used in this saw as the
following specifications:
Maximum capacity (kW)
Voltage (V)
Saw blade speed (MPM)
Blade rotating direction
Weight N.W (kg)
WARNING: To avoid electrical hazards,
fire hazard, or damage to the tool, use
proper circuit protection or circuit breaker
to avoid shock or fire, if power cord is
worn or cut, or damaged in any way,
have it replaced immediately.
Noise information according to DIN 45635
No load
Working
Earth
This metal saw is single insulated tool, so the
earth system is provided to protect you from
being shocked. The appropriate earth system is
set up as soon as this machine is plugged into
the proper power supply system. Therefore, the
standard power supply system shall be provided
for this machine in order to protect you from the
risk of shock.
- 5 -
WARNING:
DANGER
DANGER
counter-clockwise
under 60 dB
60-65 Db
0.30
230
23~75
24