- ページ 19

旋盤 Axminster AWVSLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axminster AWVSL 20 ページ。 Woodturning lathes

AWVSL (700241)

Note. The lowest speed pulley combination is furthest from the faceplate, i.e. smallest motor

pulley diameter to largest spindle pulley diameter.

Disconnect the machine from the mains supply

Locate the cover plate at the rear of the headstock. Loosen the 'star nuts' that secure the

cover plate, see fig (A) lift, slide, turn...etc. Release the locking handle to the side of switch

& speed control assembly, see (E) and swing the switch & speed control assembly to the

side. Now you have access to the belt, see (F). REFURE TO AWSL FOR INSTRUCTION

ON CHANGING THE SPEED.

Replace/refit the cover plate. Swing the switch control assembly back and secure in place

with the locking handle. Reconnect the machine to the mains supply. Give the lathe a little

'burst' to check it all runs smoothly. When you are satisfied, remove any tools you may have

been using; stow carefully away. The lathe is now ready to be used again.

Switch speed control assembly

Belt

FREEPHONE

Changing the Speed...

Un-Lock

0800 371822

A X M I N S T E R

W H I T E

Lock

Locking handle