- ページ 7

旋盤 Axminster C0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Axminster C0 14 ページ。 Mode engineer series metal turning lathe

Components should be dry, and all machined surfaces should be lightly oiled.

Always removed cutting tools, and store in a safe place.

MOTOR BRUSHES

The motor brushes may be changed by unscrewing the caps, at the upper of the motor, beneath

the headstock.

Occasionally, it may be necessary to readjust various components in order to maintain optimum

performance. The adjustments that may be performed are as follows:

A. CROSS-SLIDE ADJUSTMENTS

The cross-slide is mounted on a dovetail slide, as shown below. Between the sloping surfaces on

one side of the dovetail, a "jib strip" is inserted, which may be tightened against the dovetail under

the influence of three adjuster, or "jib" screws, mounted along it's length.

The jib screws are to be found on the right hand side of the slide, directly beneath the compound

slide handle. In time, wear will occur on the mating surfaces resulting in a "sloppiness" of action.

To adjust the jib strip, account for wear and ensure the slide moves evenly and smoothly,

proceed as follows:

1. Slacken off all lock nuts and screw in the jib screws evenly,

i.e. use the same torque for each screw. The slide should be

held firmly. Test by trying to turn the handle, but do not force

it.

2. Screw out each jib screw by one quarter of a turn only, and

nip up the lock nuts.

3. Test again, by turning the handle, the movement should be

even and smooth along its complete length.

4. If the movement is too slack, screw all adjusters "in" by one eighth of a turn, and re-try.

Similarly, if the movement is too stiff, screw "out" the adjusters by one eighth of a turn until the

correct adjustment is attained.

5. Tighten all lock nuts taking care to ensure you do not move the jib screws whilst doing so.

6. When completed, retract the slide fully and apply oil to all mating surfaces and the feed screw

thread, then wind the slid back to its normal position.

B. TAILSTOCK ADJUSTMENTS

The tailstock locked by one lock screw, if loose the lock screw the tailstock can moved to left or

right, when lock the lock screw(front the tailstock) then the it can fixed any position on the bed

way.

NOTE:

It is important that the cross-slide and compound slide adjustments are correctly out and that

there is no "sloppiness" of action. Any maladjustment will have a serious effect on the quality of

your work, as they will all be transferred to the tool tip. It is vital that there is as little movement of

the tool as possible.

ACCESSORIES

A range of accessories is available from your versatility of your machine. These are as follows:

NOTE: The accessories is "Optional accessories", you can buy it from your dealer or the

factory.