- ページ 11

旋盤 Axminster WORKSHOP AW205WLのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Axminster WORKSHOP AW205WL 17 ページ。 Woodturning lathe

Monthly

DISCONNECT THE LATHE FROM

THE MAINS SUPPLY BEFORE

CONTINUING!

1. Check the tension of the belt and adjust. If you find

the spindle is slipping or has stopped rotating check the

drive belt is under tension.

Fig 17

2. Also check the condition of the belt for signs of

fraying and extreme wear. To replace the belt first

loosen the hex bolt holding the motor plate and raise

the motor to remove the tension, see fig 17. Remove

the three screws holding the upper pulley access plate,

place safely aside, see fig 19.

Fig 19

3. Check any build up of wood shaving on the motor and spindle pulleys and clean if necessary.

4. If the tailstock has been used for drilling through the centre of workpieces, clean out the debri for

the entre of the spindle.

5. Lubricate the spring levers and other threaded parts.

Loosen the hex bolt holding the motor plate, press

down the motor assembly and re-tighten the bolt, see

fig 17-18.

Drive belt

Remove the damaged belt, insert the new 'V' belt down

into upper/lower pulley grooves, see fig 18-20.

Press down the motor to retention the belt and

tighten the Hex bolt to secure in place. Replace the side

access plate.

11 11

MAINTENANCE

Fig 18

Fig 20

Continues Over...