- ページ 7

ツール Axminster CSC500KのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axminster CSC500K 8 ページ。 Key operated woodturning chuck set

Screw the completed assembly onto your lathe. The chuck should go on effortlessly with no

binding. Screw the chuck all the way until the adapto r face contacts the shoulder of the

lathe spindle. Lock the spindle, slightly unscrew the chuck and give it a firm spin. This will

snap the chuck firmly in place.

The tightening key aligns with a pivot hole inside your chuck. The tightening key has gear

teeth which index with the scroll mechanism inside the micro key chuck. Clockwise

tightens, counter-clockwise loosens the jaws.

When turning a bowl, for safety reasons, allow a minimum

amount of wood for the chuck to grab while turning.

1. Cavity base (inside grip) - for a 2" diameter base,

minimum hole depth is 3/16".

2. Spigot base (outside grip) - for a 2" diameter base

minimum grip is 3/16".

Make sure your wood is properly aligned and balanced

Brushing is all that is needed to clean your chuck. If the chuck becomes sticky, clean with

"Dry PTFE Spray Part No: 810135" or "Camellia Oil Part No: 510018".

DO NOT allow wood chips to become compacted in the teeth of the gear

mechanism.

CAUTION: Gear mechanism should be cleaned in between uses. Excessively dirty

gear teeth may lead to mechanical failure.

Mounting the Chuck to Your Lathe...

Turning: 500-I500rpm

Sanding & Polishing: 1500-2500rpm

when mounted or re-mounted.

Use slower speeds for larger work.