- ページ 6

サンダー Axminster AWDS12HのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axminster AWDS12H 16 ページ。 Hobby series 300mm disc sander

Specific to Sanding Machines

CHECK that the belts or discs are undamaged; torn edges can pick up on the workpiece and

will cause the medium to tear, often very rapidly with accompanying sharp flapping edges.

ALWAYS offer the workpiece to the belt/disc so that the motion carries the work against the

restraining surface, (i.e. the work stop or the table, (use the left hand side of the disc).

DO NOT press too heavily against the sanding surface, all this will do is slow the sander down.

Remember, sanders work by removing small particles of material quickly and heavy pressure

works adversely to the cutting process, further, it will accelerate the rate of 'clogging' of the

abrasive surfaces, rendering the machine less efficient.

If you are attempting to sand inside curves (over the 'tracking drum') do not press at all, other

than to keep the workpiece in contact with the surface, any pressure could upset the tracking

geometry. As there is no cushioning effect to the belt passing around the drum, expect an added

vibration and compensate for it.

Sanding of certain types of timber may make the fitting of dust extraction mandatory in order to

comply with the directives of the HSE. However, even if it is not mandatory, it is strongly

recommended that you consider fitting dust extraction. It will certainly reduce the level of dust

and grit, and as it helps to remove the waste quicker will certainly prolong the longevity of the

abrasive.

Above all, OBSERVE.... make sure you know what is happening around you, and USE YOUR

COMMON SENSE.