- ページ 6

電動工具 Axminster AW422JのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axminster AW422J 8 ページ。 10-22mm narrow crown stapler

ページを印刷する

General Safety Instructions and Recommendations

whilst using Air Equipment...

A X M I N S T E R

W H I T E

Check that cutters, drills, chisels etc., are the correct type and size, are undamaged and are kept

clean and sharp, this will maintain their operating performance and lessen the loading on the tool.

Above all, OBSERVE.... make sure you know what is happening around you, and USE YOUR

COMMON SENSE.

Installation

Please study the diagram of an air installation depicted below, any

new installation should follow these guidelines. Note. Fixed

connectors can be replaced with quick release connectors, but air

leakage can cause problems at the 'connection' as they become

worn.

A) Basic Installation B) Small Workshop Installation C) Large Workshop Installation

1. Compressor 2. Regulator 3. Water trap 4. In line oiler 5. Shut off valve

6. Quick release connector 7. Fixed connector 8. Air line 9. Air tool

10. Air gallery 11. Reservoir 12. Pressure gauge 13. Water drain

(A)

(B)

Legend

Basic Installation

Small Workshop Installation

Illustration and Description of the Stapler...

Staples

Magazine

Preparing your Stapler for Use...

Check your air supply system is on, and air is available in the gallery. (Check your inline

oilers, if fitted, have sufficient oil in the reservoirs). Turn on the air to the hose line. Set the

required pressure on the regulator (We suggest 70 psi).

Note: Remember you have to bleed air through the regulator to achieve the set pressure,

do this by opening the hose line using a blow gun or duster, and setting the regulator whilst

the air is flowing. Close off the air supply to check the set presure.

DISCONNECT THE STAPLER FROM

THE AIR SUPPLY TO LOAD STAPLES

Unclip the magazine latch, and pull the magazine cover to the rear of the tool, turn the

stapler upside down exposing the staple trough. Load a clip of staples into the magazine

(Points upward). Carefully slide the magazine cover closed, so as not to break the pin clip,

or cause it to ripple. (the clearances around the rear slipper plate will govern the maximum

size of staple you can load into the tool, there is no physical check for the minimum size,

please read the specification and follow the guide lines). You will feel the resistance of the

sprung 'shoe feeder' against the clip of staples as the cover is closed, continue closing until

the cover latches shut. This 'shoe feeder' keeps the staples pressed into the receiver slot to

enable repetitious pinning.

A X M I N S T E R

W H I T E

Push Latch down