- ページ 5

グラインダー Axminster RBG200 Engineer SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axminster RBG200 Engineer Series 7 ページ。 Bench grinders

ページを印刷する

consistent

with

machine).

·Fit outer flange（3）and nut (4).

·Screw down nut(7) with 18mm spanner.

·Fix the outer guard(5) of the grinding

wheel properly with bolt (6).

· According to the above, adjust eye

shield bracket, adjustable tool test

and eye shield.

When replace the flange (1) and

法兰(1(3),the diameter of the flange

used should be at least 1/3 diameter of

the grinding wheel, and their apertures

are consistent. The swing measured from

the grinding wheel circumference is

normal. The axial wobble and the radial

wobble within 0.5mm are normal swing.

Usage

· Check that all the parts are well

fitted or adjusted.

·Start the bench grinder.

·Let the bench grinder work at

rated speed so that it can polish

well.

According to different results of polishing, you

should choose different grinding wheels.

· If necessary, you should polish working

pieces with rough grinding wheels firstly,

and then with fine grinding wheels.

·Before polishing, check the working piece

usually to make sure that there's no oil,

grease and painting feculence to avoid being

blocked up or becoming dirty

·Avoid the bench grinder over-heated.

·The working piece can only bear slight press.

·If blocked up, you can repair it with D-Mart

that

matched

handle repairing machine.

the

Maintenance and Cleaning

Using the grinder under low load requires no

maintenance.

Clean the bench grinder regularly..

Remove dust and dirt produced by polishing

with a soft brush.

Environment Protection

Putting away waste grinding wheel should

according to the requirements of environment

protection.

Picture A (RBG150ID)