- ページ 8

血圧モニター AccuMed ABP801のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AccuMed ABP801 15 ページ。 Wrist blood pressure monitor

* lf you are not going to use the unit for a long period of time (approximately three months

or more), remove the batteries.

* Replace worn batteries with their polarities in the correct direction.

TIME AND VOICE ON/OFF OF SYSTEM SETUP

1. Press the "SET" key to turn on.

2. Press and hold the "SET" key until the year number displays and flashes

on LCD to enter the settings mode.

3. Press the "MEM" key to adjust the year, then press the "SET" key again to

save your setting and enter the month setting mode.

4. Press the "MEM" key to adjust the month. Following the same steps to

adjust date/hour/minute/(Voice on/off) until the setting is completed ("

" is

On, "

" is the Off) Non-talking model does not have this function, or you may choose

method No.2 to set the voice.

Method No.2 for voice setting: Please press and hold the "MEM" button when the device is in

the shutdown state to enter the voice setting. Please press the "MEM" button again to choose

"ON" or "OF". Press the "ON/OFF" button to quit.

The monitor has two kinds of blood pressure display units mm Hg(mmHg), kPa (kPa). (mmHg

is the factory default). While the monitor is off, press and

hold the ON/OFF button for 5 seconds. The monitor will

boot up and measure showing the other unit. (If it was in

mmHG it will change to kPa and vice versa.) Also the

stored values will be shown in the new unit.