- ページ 11

サンダー Axminster Trade 106005のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Axminster Trade 106005 16 ページ。 Oscillating sander

ページを印刷する

TROUBLE

Motor does not run when

power switch is turned "ON".

Motor does not run at full

speed.

Motor does not reach full

power.

Motor overheating

Excessive machine vibration Machine is incorrectly

Mark on workpiece

Sanding drum turns in wrong

direction

Burns on workpiece

TROUBLESHOOTING

CAUSES

1. Switch is burned out.

2. Connection wire is loose

or damaged.

1. Power voltage is too low.

2. Motor is damaged.

1. Incorrect power wiring.

2. Overload.

1. Motor is dirty.

2. Motor is damaged.

leveled.

1. Sanding drum is

damaged.

2. Sanding cloth on drum is

worn in some areas.

Wrong phase or voltage

Wrong abrasive grit on

sanding cloth

CORRECTION

1. Replace the switch.

2. Tighten or replace the

wire.

1. Test voltage.

2. Check and repair motor.

1. Replace with the correct

size power wiring.

2. Reduce sanding load.

1. Clean motor.

2. Check and repair motor.

Adjust machine leveling

1. Replace the sanding

drum.

2. Replace sanding cloth

Make sure the phase and

voltage comply with machine

requirement.

Use coarser grit to remove

more material from

workpiece.