- ページ 5

サンダー Axminster Trade AT220BSのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Axminster Trade AT220BS 18 ページ。

Referring to Figure 3:

4. The sanding platen (A) is presently in the

horizontal position. Pull lock handle (B) forward

to unlock the platen assembly.

5. Tilt sanding platen to the vertical position (C),

which will look like D in Fig. 4; then push the

lock handle (B) to lock the platen assembly in

place.

Note: Do not turn the lock handle. Turning or

rotating the lock handle will change the tension

of the locking assembly. This may cause the

locking assembly not to work, making it

necessary for adjustment before using the

machine.

Sanding Belt Installation

Referring to Figure 5:

1. From the rear of the sander, remove the belt

guard (A) by unscrewing two lock knobs (B).

Take out the sanding belt and removable fence

from behind the belt guard.

2. Place the handle (C) on belt tensioning

lever (D). Remove the tension from the

mechanism by moving the handle (C) to the

Loose position.

3. Place belt on both rollers so that the edge of

the belt is even with the edge of the rollers.

Note: Make sure that direction arrow on belt

matches the direction indicator on the top of

the platten.

4. Tighten the belt by moving the tension arm

handle (C) to the Tight position. Rotate the belt

by hand in the direction indicated by the arrow

on top of the platten. If the belt tracking needs

adjustment, see Belt Tracking Adjustment

Figure 3

Figure 4

Figure 5