- ページ 12

サンダー Axminster Trade AT2260BS2のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Axminster Trade AT2260BS2 19 ページ。

Contour Sanding

Referring to Figure 19:

Contour sanding is done from the extension table

mounted on the motor where the sanding belt

wraps around the drive drum (D). To set up the

sander for contour sanding:

1. Loosen the two lock knobs (C) that secure the

drum guard & dust port (E).

2. Swing the end guard (E) back, bringing the

drive drum (D) into view.

3. Tighten the lock knobs (C).

4. Mount the extension table (A) to the sander by

inserting the post (B) into the bracket (F).

5. Set the table to the desired height, then secure

into position by tightening the lock knob (G).

Important: When the extension table (B) is not in

use, the drum guard & dust port (E) should always

be in the closed position so the drive drum (D) is

not in view.

Figure 19