- ページ 11
防犯カメラ Axon Fleet 3のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Axon Fleet 3 19 ページ。 Camera system
ページを印刷する
Axon Fleet 3 Camera System
EVENT Mode (Starting Recording)
To begin recording, do one of the following:
Use the Fleet Dashboard application to start recording.
•
Press the Primary or Secondary Button on the Dual-View Camera
•
If your vehicle is configured to begin recording automatically, your camera will
•
transition from BUFFERING to EVENT mode when the Fleet Hub detects a trigger.
When your camera starts recording, you will hear 2 beeps. The moment EVENT mode
begins, both video and audio are recorded from the camera and GPS coordinates are
recorded (Note: GPS coordinates are provided by the Fleet Hub). This will continue
throughout the duration of the recording until the recording is stopped. Any "buffered"
video directly preceding the event is saved and attached at the beginning of the event
recording (Note: With default settings, the buffered video does not contain audio).
The camera provides you with indications that it is recording in EVENT mode:
o
o
To stop recording and return to BUFFERING mode:
Use the Fleet Dashboard application to stop recording, or
•
Single press the PRIMARY button to end recording on the Dual-View Camera, or
•
single press the SECONDARY button to end recording on the Interior Camera.
The system will beep once (with a long tone).
Recording Resolutions and Specifications
Both the Dual-View Camera and Interior Camera can be set to various aspect ratios and
resolutions up to 1080p, as shown in the following table. Higher resolution videos are larger,
take longer to upload and consume more storage on Axon Evidence. Your agency-wide
camera recording resolutions can be selected by an agency administrator in Axon Evidence.
Note: Video is stored on the HUB, not either of the cameras.
Axon Enterprise, Inc.
At the start of an event and every 2 minutes during an event, the system
beeps twice.
The Operation LED on the camera or controller will be blinking red
User Manual
Page 11 of 19