- ページ 6

バッテリーチャージャー AccuPower IQ-328のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AccuPower IQ-328 9 ページ。 Intelligent fast charger

Entlade- und Ladestrom Tabelle / Charging and Discharging chart

Strom im Entlademodus / DISCHARGE MODE Current

Gewählter Entladestrom

User-selected discharging current

Anschließender Ladestrom

Thereafter charging current

Once the batteries have been discharged the charging process will start automatically.

The charging Current is always the double of the adjusted discharge current. For

example, select a discharge current of 350 mA, the charging current 700 mA. Therefore,

make sure to select a not too high discharge current.

The display shows "Full " when the Charging is completet. As soon as "Full" is

displayed, you can switch by the DISPLAY button, between charging time, voltage and

capacity.

Note: The MODE button must be hold about three seconds. Only than you can select

the functions CHARGE, DISCHARGE, TEST and REFRESH by pressing the MODE

button again.

REFRESHING "REFRESH DISCHARGE"

The DISCHARGE-REFRESH function can provide for older or a long time unused

batteries, the optimum capacity back. This function can only select by by press and hold

the MODE button. After the Function has been selected DISCHARGE-REFRESH ". You

can select the discharge current, by the CURRENT button. (see table at EMPTY) As

soon as this mode is selected and started, the charger will start to discharge the inserted

batteries, then to load. This process will be automatically repeated until the battery

charger detects no increase in capacity more. The batteries have reached their

maximum capacity.

6/8

100 mA

200 mA

Entlade Modus

Discharge mode

Entladestrom: 350 mA

Discharging current: 350 mA

Auffrisch-Modus (der Akku wird entladen)

Refresh mode (the battery is being discharged)

Entladestrom: 350 mA

Discharge current: 350 mA

250 mA

350 mA

500 mA

700 mA

500 mA

1000 mA