制御システム cinetto B-MOVED PS48KM10002P0002のPDF クイック・スタート・インストールおよびセットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。cinetto B-MOVED PS48KM10002P0002 19 ページ。 Wave sensor
cinetto B-MOVED PS48KM10002P0002 にも：クイック・ユース・マニュアル (20 ページ)

ページを印刷する

Quick start installation and setup

1. Initial condition of the wardrobe

Do not plug the control unit to electricity before connecting all the engines (see connections at pages 4-5-

6-7).

Connect all the electric motors of the transmission bars to the control unit according to the wardrobe confi guration.

After connecting all the electric motors to the control unit close manually all the doors.

2. Control unit power supply

00:00:10

3. Self-learning cycle

After connecting to the power supply, wait at least 10 seconds, to allow to the control unit to

check the wardrobe confi guration.

00:00:03

After

connecting

electric

control unit and after closing

manually all the doors is

possible

control unit to the power

supply.

Start the self-learning cycle to make the

automatic set-up of the run of the doors

pressing at least 3 seconds the "SET /

RESET" button on the power unit. All the

doors, one by one, starting from the fi rst left

door on the wardrobe, will move at reduced

speed until their fi nal stoppers.

This operation, until all the doors record their

run, may take some minutes.

During the self-learning cycle do not

stop or put obstacles towards the doors

and keep the door's run free.

If the position of the fi nal stoppers

is modifi ed, please repeat the self-

learning cycle again.

Assembly Instructions Cinetto

B-moved.

all

the

motors

the

connect

the