- ページ 3
バスルーム設備 Axor AXOR 250 1jet 35287007のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Axor AXOR 250 1jet 35287007 16 ページ。
ページを印刷する
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The arm of the shower head is intended only to hold
the shower head. Do not load it down with other
objects!
Children as well as adults with physical, mental and ⁄or
sensoric impairments must not use this product without
proper supervision. Persons under the influence of
alcohol or drugs are prohibited from using this product.
Do not allow the streams of the shower touch sensitive
body parts (such as your eyes). An adequate distance
must be kept between the shower and you.
Pursuant to DIN VDE 0100 T 701 section 701.415.2,
the overhead shower must be connected to potential
bonding.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
⁄ The mesh washer must be insert to protect the shower
against incoming dirt by pipework. Incoming dirt leads
to defects or⁄and can damage parts of the shower;
such caused faults voids all liability and guarantee
claims.
F A U L T
⁄ Head shower extremely leaky
⁄ Shower drips continuously
⁄ Water drips from showerhead a short
time after the valve is closed
⁄ Sprays not operating properly
A S S E M B L Y (see page 04)
T E C H N I C A L D A T A
Operating pressure:
Recommended operating pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
C A U S E
⁄ Head shower soiled ⁄ scaled
⁄ Shut-off unit damaged
⁄ Normal clearing of pipes
⁄ Flow pressure too low
⁄ Filters are dirty
⁄ Head shower soiled ⁄ scaled
(1 MPa = 10 bar = 147 PSI)
Do not use silicone containing acetic acid!
D I M E N S I O N S (see page 08)
F L O W D I A G R A M (see page 09)
S P A R E P A R T S (see page 15)
P O T E N T I A L E Q U A L I S A T I O N
(see page 06)
C L E A N I N G (see page 10)
O P E R A T I O N (see page 09)
R E M E D Y
⁄ Clean ⁄ descale head shower
(see page 10)
⁄ Exchange shut-off unit
⁄ Check water pressure (If a pump has
been installed check to see if the pump
is working).
⁄ Increase water pressure
⁄ Clean filters (see page 12)
⁄ Clean ⁄ descale head shower
(see page 10)
0 3
EN
max. 0,6 MPa
0,25 - 0,4 MPa
max. 60°C
70°C ⁄ 4 min